Comfort Adjustments - Pride Victory Owner's Manual

V I I .
WARNING! Remove the key from the key switch before adjusting the tiller or the seat. Never
attempt to adjust the tiller or the seat while the Scooter is in motion.
TILLER ANGLE ADJUSTMENT
You can adjust the tiller to many positions. The tiller adjustment lever locks the tiller in place. It has a spring-loaded
mechanism that enables you to rotate it and change its position.
1. Turn the tiller adjustment lever anticlockwise until it is loose. If the tiller adjustment lever comes in contact with
the tiller basket, pull it outward, turn it clockwise, and release it. Continue to loosen until the tiller is able to
move. See figures 11 and 11A.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment lever clockwise until it is tight. If the tiller adjustment lever comes in contact with the
tiller basket, pull it outward, turn it anticlockwise, and release it. Continue to turn the lever until it is tight. The
tiller may be lowered to the center of the floorboard and locked in place for storage. See VIII. “Disassembly
and Assembly.”
TILLER ADJUSTMENT
LEVER
Figure 11. Tiller Angle Adjustment
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of three different
heights. See figure 12.
1. Remove the seat from your Victory. See VIII. “Dis-
assembly and Assembly.”
2. Use the attached ring to pull and remove the ball
detent pin from the lower seat post.
3. Raise or lower the upper seat post to the desired
seat height.
4. While holding the upper seat post at that height,
match up the holes in the upper seat post and the
lower seat post.
5. Fully insert the ball detent pin.
6. Replace the seat.
NOTE: The supplied nut, bolt, and washers can be used as an alternative to the ball detent pin.
Victory
C O M F O R T A D J U S T M E N T S
TILLER BOOT
TILLER RELEASE
BUTTON
PULL OUT TO REPOSITION
Figure 11A. Reposition Tiller Adjustment Lever
(Tiller Boot Removed For Clarity)
SEAT PEDESTAL
UPPER SEAT POST
LOWER SEAT
POST
Figure 12. Seat Height Adjustment
TILLER
RELEASE
BUTTON
LOCATING HOLES
Ball Detent Pin
27