Description; Onboard Battery Charger; Main Circuit Breaker - Pride Sundancer Owner's Manual

REAR SECTION
The electronic controller module, onboard battery charger, main circuit breaker reset button, batteries, motor/
transaxle assembly, and the manual freewheel lever are located on the rear section of your Scooter. The anti-tip
wheels are at the rearmost part of your Scooter. See figures 7 and 8. Refer to VIII. “Disassembly and Assembly”
for instructions on removing the rear shroud.

ONBOARD BATTERY CHARGER

ELECTRONIC CONTROLLER
MODULE
MAIN CIRCUIT
BREAKER RESET BUTTON
Figure 7. Utility Tray Components
Electronic Controller Module
This module is located behind the batteries and at the forward right corner of the rear section. The electronic
controller module receives electrical signals from the console controls and sends power to the motor, the brakes,
and the optional lighting system.
WARNING! Do not expose the electronic controller module to moisture. If it does become exposed
to moisture, do not attempt to operate your Scooter until it has thoroughly dried.
Onboard Battery Charger
The onboard battery charger converts household current (AC) to direct current (DC) and charges your batteries.
See V. “Batteries and Charging.”
n The charger is located on the utility tray.
n The charger is a gray-colored box with a green LED indicator on the exterior of its case.

Main Circuit Breaker

When the voltage in your batteries becomes low or your Scooter is heavily strained because of excessive loads, the
main circuit breaker may trip to protect the motor and electronics from damage.
n The main circuit breaker reset button is mounted on the electronic controller module cover.
n The main circuit breaker reset button pops out when the breaker trips.
n When the breaker trips, the entire electrical system of your Scooter is shut down.
Sundancer
I V . D E S C R I P T I O N
AMMETER
BATTERY
MOTOR/TRANSAXLE ASSEMBLY
ANTI-TIP WHEELS
Figure 8. Rear Section Components
MANUAL FREEWHEEL
LEVER
13