Preparations - Sony DCR-DVD100 Service Manual

1-1-2.

Preparations

Note1: For details of how remove the cabinet and boards, refer to "2.
DISASSEMBLY".
Note2: When performing only the adjustments, the lens block and boards
need not be disassembled.
Note3: Before performing the adjustments, check the data of page: 0,
address: 10 is "00". If not, set data: 00 to this address.
1) Connect the equipment for adjustments according to Fig. 6-1-3.
Note4: As removing the cabinet (R) assembly (removing CN1007 of the
VC-307 board) means removing the lithium 3V power supply
(BT5201 on the CK-127 board), data such as date, time, user-set
menus will be lost. After completing adjustments, reset these data.
But the self-diagnosis data and the data on history of use (user
initial power on date, final condensation occurrence data) will be
kept even if the lithium 3V power supply is removed. (Refer to
"6-3. Service Mode" for the self-diagnosis data and the data on
history of use.)
Note5: Setting the "Forced MOVIE mode".
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press the PAUSE
button.
The above procedure will enable the camera power to be turned
on with the control switch block (PS-CX5500) removed. After
completing adjustments, be sure to exit the "Forced MOVIE mode".
Note6: Exiting the "Forced MOVIE mode".
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press the PAUSE
button.
3) Select page: 0, address: 01, and set data: 00.
Pattern box
Front of the lens
6-5
DCR-DVD100/DVD100E
1.5 m
Fig. 6-1-2.