Sony DCR-DVD100 Service Manual page 158

DSC-P100/P120
1-4-3. Adjusting Method
1. CAMERA Adjustment 1
Note: Connect the PC and camera with the USB multi cable (1-
829-109-11) without using the multiple connector (1-818-
383-11) when performing "CAMERA Adjustment 1".
[Automatic Adjustment Program execution items and
sequence]
1. Data Setting during Camera Adj.
2. Flange Back Adj.
3. Release of Data Setting during Camera Adj.
[Adjusting method]
[CAMERA Adjustment 1 Start]
1) Click the
2) The Automatic Adjustment Program executes "1. Data Setting
during Camera Adj.".
3) Upon successful completion of the "1. Data Setting during
Camera Adj.", the following message is displayed. Set the sub-
ject by referring to "Preparation of Flange Back Adj.".
[OK]
4) If the button is clicked, "2. Flange Back Adj." and "3.
Release of Data Setting during Camera Adj." will be executed.
5) Upon successful completion of all items of the CAMERA
Adjustment 1, the following message is displayed. Click the
[OK]
button.
button.
Fig. 6-1-16
Fig. 6-1-17
Preparation of Flange Back Adj.
1) The minipattern box is installed as shown in the following fig-
ure.
Note 1: The attachment lenses are not used.
Note 2: Take care not to hit the mini-pattern box when ex-
tending the lens.
2) Install the minipattern box so that the distance between it and
the front of lens of camera is less than 3 cm.
3) Make the height of minipattern box and the camera equal.
4) Check the output voltage of the regulated power supply is the
specified voltage ± 0.01 Vdc.
5) Check that the center of Siemens star chart meets the center of
shot image screen with the zoom lens at TELE end and WIDE
end respectively.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjustment the power sup-
ply output voltage to the specified voltage writ-
ten on the sheet which is supplied with the mini-
pattern box.
Minipattern box
Output voltage : Specified voltage ± 0.01 Vdc
Red (+)
Black (–)
Yellow (SENS +)
White (SENS –)
Black (GND)
6-14
Below 3 cm
Camera
Regulated power supply
Output current : more than 3.5 A
Need not connected
Fig. 6-1-18