Features - Kidde SMOKE AND CARBON MONOXIDE ALARM User Manual

Features

• Permanent
monoxide sensors.
• Smoke alarm takes precedence when both
smoke and carbon monoxide are present.
• Alarm/Voice message warning system that alerts you
of the following conditions in the manner described
below, thus eliminating any confusion over which
alarm is sounding:
FIRE: The alarm/voice pattern is three long alarm
beeps followed by the verbal warning message "FIRE!
FIRE!". This pattern is repeated until the smoke is
eliminated. The red Light Emitting Diode (LED) light
will flash while in alarm/voice mode.
CARBON MONOXIDE: The alarm/voice pattern is
four short alarm beeps followed by the verbal warning
message "WARNING! CARBON MONOXIDE!" After
four minutes the alarm/voice pattern will sound once
every minute until the unit is reset, or the CO
eliminated.
alarm/voice mode.
LOW BATTERY: When the batteries are low and
need replacing the red LED light will flash and the unit
will "chirp" one time, followed by the warning
message "LOW BATTERY." This cycle will occur once
every minute for the first hour. After the first hour the
red LED light will continue to flash every minute
accompanied by the "chirp" only sound. The voice
message "LOW BATTERY" will sound once every
fifteen minutes during the "chirp" only cycle. This will
continue for at least seven days.
independent
The red LED light will flash while in
smoke
6
and carbon