Tamper Resist Feature - Kidde SMOKE AND CARBON MONOXIDE ALARM User Manual

Operating/Installation Instructions
there is a location that has 'Replace by' printed on it. Remove
mounting plate from the back of the unit by holding the rim of
the mounting plate and twisting counterclockwise (left). Write
the replace-by date on the label. The date written on the label
should be seven (7) years after the date the unit is initially
powered up.
Hold the mounting plate against the selected installation location
(wall or ceiling) and mark the centre of the holes with a pencil.
To ensure aesthetic alignment of the alarm with the hallway, or
wall, the "A" line on the mounting plate must be parallel with
the hallway when ceiling mounting, or horizontal when wall
mounting. Drill a hole through the pencil marks and use the
enclosed screws and anchors to secure (use 5mm drill bit for
anchor holes). Align the Smoke/CO Alarm with the mounting
plate and rotate clockwise (right) until the unit is aligned.
F F I I G G U U R R E E 1 1
Two labels are included with your alarm. They have important
information on what to do in case of an alarm. Add the phone
number of your emergency service provider in the space
provided. place one label next to the alarm after it is mounted,
and one label near a fresh air source such as a door or window.
D. Tamper Resist Feature:
To make your smoke alarm somewhat tamper
resistant, a tamper resist feature has been provided.
Remove
When mounting in the
hallway, the "A" line should
be parallel with the hallway.
A A
Alignment Marks
Install
15