Operating/Installation Instructions; Step 1 Installing Batteries; Features - Kidde SMOKE AND CARBON MONOXIDE ALARM User Manual

Carbon Monoxide Alarm Features
CAUTION: This alarm will only indicate the presence
of carbon monoxide gas at the sensor.
monoxide gas may be present in other areas.
Individuals with medical problems may consider using
warning devices which provide audible and visual
signals for carbon monoxide concentrations under 30
ppm.

Operating/Installation Instructions

Step 1
Installing Batteries:
Batteries were not installed at the factory and
must be installed for the unit to operate! Install the
three (3) AA batteries in the back of the Smoke/CO
Alarm.
• The mounting plate must be removed from the
back of the unit to install batteries. To remove, hold
the mounting plate and twist counterclockwise (left).
• The battery polarity markings on the bottom of
the battery compartment must be adhered to.
• Batteries must be installed in the sequence
shown. If batteries seem difficult to install, they're not
being installed in the proper sequence.
Batteries Must Be Installed in Order Shown Below:
Install
3.
Last
Install
2.
Second
Install
1.
First
AA-battery
3
INST ALL
THIRD
2
INST ALL
AA-battery
SECOND
1
INST ALL
FIRST
AA-battery
10
Carbon
INSTALL 3
+
WARNING:
LAST
2
+ INSTALL
BATTERIES SECOND
MISSING
INSTALL 1
+
FIRST