Table of Contents
Advertisement
9. Wiring / Installation / Activation
NOTE: To avoid false low battery chirping (model will also announce
"Activate Battery") one of the following steps must be taken to ensure
activation: (Battery activation is confirmed with a beep and voice
"Push Test Button.")
A. Locate the red wheel on the back of the unit - turn the red wheel to
the "ON" position using the included white activation tool or a
standard screwdriver. Battery will remain active to allow for installation on mounting bracket.
B. Orient the unit with LED pointing to the right as shown in Figure 9-B, and rotate the unit a full 90 degrees
clockwise onto the mounting bracket. To allow for installation, battery will remain active when unit is removed
from mounting bracket.
Mounting Bracket
To ensure aesthetic alignment,
install the unit onto the mounting
bracket as shown, and rotate fully
90 degrees clockwise.
Note orientation
of "A" line.
LED
Remove
Install
Figure 9 -B
USE ACTIVATION
TOOL OR SCREWDRIVER
Figure 9 -A
15
Advertisement
Table of Contents
