Operating/Installation Instructions; Step 1 Installing Batteries - Kidde 900-0122-UK User Manual

Operating/Installation Instructions

Step 1
Installing Batteries:
Batteries were not installed at the factory and must be
installed for the unit to operate! Install the three (3) AA
batteries in the back of the Smoke/CO Alarm.
• The mounting plate must be removed from the back of the
unit to install batteries. To remove, hold the mounting plate
and twist counterclockwise (left).
Batteries Must Be Installed in Order Shown Below:
Install
3.
Last
Install
2.
Second
Install
1.
First
• The battery polarity markings on the bottom of the battery
compartment must be adhered to.
• Batteries must be installed in the sequence shown. If batteries
seem difficult to install, they're not being installed in the
proper sequence.
• Smoke/CO Alarm will not engage to bracket unless all three
batteries are installed. Removal of any or all batteries will
render the Smoke/CO Alarm inoperative!
• After the batteries are correctly installed the unit will beep
once and the red LED light will flash.
After 20-30 seconds the green LED light will flash indicating
the unit is now operational.
CAUTION: Your Smoke/CO Alarm is sealed and the
cover is NOT removable!
8
AA Battery
3
INSTALL
THIRD
2
INSTALL
AA Battery
SECOND
1
INSTALL
FIRST
AA Battery
3.
: INSTALL 3
+
LAST
WARNING
2.
INSTALL 2
+
BATTERIES SECOND
MISSING
INSTALL 1
+
FIRST
1.