Appendix; Configuring The Switch With The Cli-Based Setup Program - Cisco Catalyst 2970 Hardware Installation Manual

Configuring the Switch with the
CLI-Based Setup Program
This appendix provides a command-line interface (CLI)-based setup procedure
for a standalone switch. For product overview information, see
"Product Overview."
safety warnings in
on rack-mounting your switch, connecting to the switch ports, or connecting to
the small form-factor pluggable (SFP) modules, see
Installation."
These steps describe how to do a simple installation:
1.
2.
3.
4.
5.
6.
OL-6422-01
Before connecting the switch to a power source, review the
Chapter 2, "Switch Installation."
Accessing the CLI, page C-2
Taking Out What You Need, page C-4
Connecting to the Console Port, page C-5
Starting the Terminal Emulation Software, page C-6
Connecting to a Power Source, page C-7
Entering the Initial Configuration Information, page C-8
A P P E N D I X
Catalyst 2970 Switch Hardware Installation Guide
C
Chapter 1,
For installation procedures
Chapter 2, "Switch
C-1