Preparing For Installation; Warnings - Cisco Catalyst 2970 Hardware Installation Manual

Preparing for Installation

Warnings

Warning
Warning
Warning
Warning
Warning
Warning
Warning
Catalyst 2970 Switch Hardware Installation Guide
2-2
These warnings are translated into several languages in the Regulatory
Compliance and Safety Information for the Catalyst 2970 Switch document that
shipped with the switch.
Attach only the Cisco RPS (model PWR675-AC-RPS-N1) to the RPS receptacle.
Statement 100C
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Read the installation instructions before connecting the system to the power
source. Statement 1004
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals. Statement 43
Do not stack the chassis on any other equipment. If the chassis falls, it can
cause severe bodily injury and equipment damage. Statement 48
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device. Statement 1019
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use. Statement 39
Chapter 2 Switch Installation
OL-6422-01