Removing Screws From The Switch; Attaching Brackets To The Catalyst 2970 Switch - Cisco Catalyst 2970 Hardware Installation Manual

Installing the Switch
Note

Removing Screws from the Switch

Figure 2-1 Removing Screws from the Catalyst 2970G-24T Switch
13
14
15
16
17 18
13 X
19 20
21 22
23
24
14 X
Catalyst 2970 Switch Hardware Installation Guide
2-10
To install the switch in a 19-inch or 24-inch rack (24-inch racks require optional
mounting hardware), follow the instructions described in these procedures:
Removing Screws from the Switch, page 2-10
•
• Attaching Brackets to the Catalyst 2970 Switch, page 2-11
Mounting the Switch in a Rack, page 2-18
•
Attaching the Cable Guide, page 2-19
•
Installing the switch in a 24-inch rack requires an optional bracket kit not included
with the switch. You can order a kit containing the 24-inch rack-mounting
brackets and hardware from Cisco. The kit part number is RCKMNT-1RU=.
If you plan to install the switch in a rack, you must first remove screws in the
switch chassis so that mounting brackets can be attached.
to remove the chassis screws in a Catalyst 2970G-24T switch.
C a ta ly st 2
9 7 0
23 X
SE RI ES
24 X
Figure 2-2 shows how to remove the chassis screws in a Catalyst 2970G-24TS
switch.
Chapter 2 Switch Installation
Figure 2-1 shows how
OL-6422-01