Picture Setting - Logik L39FE12 Instruction Manual

Picture Setting

Allows you to set your preferred picture mode.
1. Press the MENU button on the remote control and then press the
buttons to select the PICTURE menu and then press the OK button.
2. Press the
buttons to select the following picture options and then
press the OK button.
3. Press the buttons to select the options. Press the OK button and then press the
setting.
Picture Mode
Cycles among picture mode: Standard / Mild / User / Dynamic.
Contrast
Brightness
Colour
Sharpness
Tint (For NTSC
format)
Colour Cycles among colour temperature: Medium / Cool / User / Warm.
Temperature
Adjusts the colour components independently to achieve a warm or cool
(for User mode).
• Red:
• Green:
• Blue:
L39FE12_IB_120524_Glo.indd 25
Alternative
You may press the P.MODE button to select the picture mode directly.
Adjusts the difference between light and dark levels
in the picture (for User mode).
Increases or decreases the amount of white in the
picture (for User mode).
Controls the colour intensity (for User mode).
Adjusts the level of crispness in the edges between
light and dark areas of the picture (for User mode).
Adjusts the balance between red and green levels
(Tint is only available for NTSC signal reception).
Increases red tint
Increases green tint
Increases blue tint
CHANNEL
PICTURE
SOUND
TIME
OPTION
LOCK
EXIT
EXIT
Picture Mode Standard
Colour Temperature
Aspect Ratio
Noise Reduction
Screen
buttons to adjust each option's
Picture Mode Standard
Contrast 82
Brightness 50
Colour 50
Sharpness 50
Tint 50
BACK EXIT MENU
Colour Temperature Medium
Red 40
Green 31
Blue 50
BACK EXIT MENU
GB
25
24/05/2012 5:23 PM