Connect The Sf61B To An Intermec Sd62 Base Station; Disconnect The Sf61B From An Sd62 Base Station - Intermec SF61 User Manual

Chapter 2 — Connect the SF61B
Connect the SF61B to an Intermec SD62 Base
Station

Disconnect the SF61B from an SD62 Base Station

30
You can connect up to seven Intermec Bluetooth scanners to the
SD62 Base Station.
Note: If you are connecting the SR61B to the SD62 base station use
the SD62 Base Station User's Guide and the SD62 system command file
in EasySet for connections and setup.
To connect up to 7 scanners
1 Connect the SD62 base station to a host device using the correct
cable for your interface.
See the SD62 Base Station User's Guide available on the Intermec web
site at www.intermec.com
SD62.
2 With each scanner you want to connect, scan the Bluetooth
System Connect bar code label on the SD62 base station and wait
for the connection to be established.
The scanner beeps twice, the green status light flashes twice and
the blue Intermec Ready-to-Work indicator starts blinking (may
blink for a few seconds). When the scanner connects to the base
station it emits a series of beeps from low to high. The blue
Intermec Ready-to-Work indicator turns on and stays on for both
the scanner and base station.
To disconnect your SF61B from the SD62 base station
1 Read the Bluetooth Device Disconnect bar code.
Bluetooth Device Disconnect
The SF61B emits the "disconnect successful" beep sequence (series
of beeps from high to low) and the SF61B's Intermec Ready-to-
Work indicator goes off.
for details on how to connect your
SF61 Cordless Scanner User's Guide