Hid Connection - Intermec SF61 User Manual

Chapter 2 — Connect the SF61B
32
This section will provide the procedure for each type of connection.
Note: To connect up to EasySet, Intermec's scanner setup software,
running on a Windows PC you can use either of the following:
• a HID Bluetooth connection
• a host-initiated (Outgoing) SPP Bluetooth connection
See Configure Your Scanner with EasySet
on how to install and use EasySet.

HID Connection

When connected in HID, connection information is stored, meaning
that if the scanner loses the connection (out of range, low battery,
etc.), it will try to reconnect as soon as possible (back into range,
charged battery, etc.).
To connect in HID device profile
1 Before trying to pair and connect your scanner, make sure that:
• the scanner is not already trying to establish a Bluetooth
connection (blinking blue Intermec Ready-to-Work indicator),
in this case read the Bluetooth Device Disconnect bar code:
Bluetooth Device Disconnect
• the scanner is not already paired with your Bluetooth device
using another profile, in this case remove it from your host's
list of Bluetooth devices
• your host is equipped for Bluetooth communication
• the scanner is turned on (if not pull the trigger to turn it on)
2 Scan the HID Bluetooth device profile configuration code:
Bluetooth device profile - HID
3 Pair the scanner with your device.
in Chapter 3 for details
SF61 Cordless Scanner User's Guide