Intermec SF61 User Manual page 87

SF61 Cordless Scanner User's Guide
7 Click OK to continue.
Note: If you do not proceed with the firmware upgrade procedure
within 5 minutes, the scanner performs a restart (emits two beeps and
vibrates). Close WinFlash and close EasySet and repeat the entire
procedure including removing your SF61B from the host's list of
Bluetooth devices and re-pairing with the host system.
If you cannot re-pair successfully after interrupting the software
upgrade (you cannot see the Outgoing and Incoming virtual COM
ports in your host PC's Bluetooth settings), try the following
workaround:
• remove your scanner from your host's device list if present
pair and connect your scanner using the HID profile
•
• disconnect your scanner from this HID connection (your
scanner should no longer be present in the host's device list)
• repeat the entire firmware upgrade procedure including
removing your SF61B from the host's list of Bluetooth devices
(if applicable) and re-pairing with the host system
8 Select the Outgoing COM port your SF61B is connected to.
Chapter 4 — Troubleshoot and Maintain the SF61B
75