Using Your Rs 195 Headphone System; Switching Your Wireless Headphone System On - Sennheiser RS195 Instruction Manual

Using your RS 195 headphone system

VOLUME
20 | RS 195
Using your RS 195 headphone system

Switching your wireless headphone system on

WARNING
Danger due to high volume levels!
Listening at high volume levels can lead to permanent hearing
defects.
Before putting the headphones on and before toggling between
your audio inputs, adjust the volume on the headphones to a
low level. Toggling between different inputs may cause an enor-
mous volume jumps that can damage your hearing.
Do not expose yourself to high volume levels for long periods of
time.
1 Switch your audio source on.
If you are using the headphone socket (see page 14) to connect to your
audio source, adjust the volume of the headphone socket on your audio
source (e.g. TV) to at least the medium level.
2 Push the AUDIO INPUT SELECTION
audio source (see page 21).
The status LED on the transmitter lights up green.
3 Press and hold the HDR power button
the headphones on.
The transmitter in standby mode recognizes the active paired head-
phones and automatically transmits a signal. The status LEDs on the
transmitter and the headphones light up green.
ON ON
AUTO-ON
2s
If the headphones are brought outside the transmission range or if
there is no audio signal received from the transmitter for more than
5 minutes, the headphones switch off automatically.
switch up or down to select your
for approx. 2 seconds to switch
Digital
Analog