Putting the RS 165 into operation
Using the RS 165 headphone system
Switching your wireless headphone system on
WARNING
Danger due to high volume levels!
Listening at high volume levels can lead to permanent hearing
defects.
Before putting the headphones on, adjust the volume on the
headphones to a low level.
Do not expose yourself to high volume levels for long periods of
time.
1
Switch your audio source on.
If you are using the headphone socket (see page 13) to connect to your
audio source, adjust the volume of the headphone socket on your audio
VOLUME
source (e.g. TV) to at least the medium level.
2
Press and hold the HDR power button
the headphones on.
The transmitter in standby mode recognizes the active paired head-
phones and automatically transmits a signal. The status LEDs on the
transmitter and the headphones light up green.
1
ON
ON
If the headphones are brought outside the transmission range or if
there is no audio signal received from the transmitter for more than
5 minutes, the headphones switch off automatically.
for approx. 2 seconds to switch
2
AUTO-ON
2s
RS 165
| 19