6.2 Adjusting the Level of Curl Correction of a Custom Paper Type
1. Press [Change] next to <Curl Correction Level>.
2. Press [-] or [+] under <Face Up Output> or <Face Down Output> to correct the level of
paper curl > press [OK].
You can adjust the curl correction level for custom paper types.
Paper curl is negated by adjusting the paper in the opposite direction to which it is curled. Make
test copies or prints on the paper that you have adjusted, and check the curl correction level.
Note:
This mode may affect paper feeding. Since increasing the value to a great extent may cause
paper jams, adjusting the values in small increments is recommended.
Reference:
To determine the direction of the paper curl, place the paper in the same direction as it
is output to the output tray.
Adjust the curl correction level in the direction opposite to that of the printed-paper.
Trouble Shooting Information for C7000VP series
Page 118
Rev. 2.0
2010/09/17