5. Adjusting the Skew Correction Level of the fed paper
1. Press [Skew Correction Level Adjustment].
2. Enter the value by pressing [+] or [-].
If the printed image is slanted only on the particular paper (such as Thin Paper), this feature
may enable you to adjust the transferring position of the paper.
The skew correction roller is located in the feeding unit of the marking engine. It adjusts the
registered position of fed paper by pushing the paper diagonally against the wall inside the
feeding unit. If the setting of skew correction level is incorrect, the printed image is slanted.
To increase the pressure and speed of the skew correction roller to push the paper, as shown
below, press [+].
Note:
This feature will affect the paper feeding performance. Changing the value extensively may
cause a paper jam. So, start with a low value and change it gradually.
Trouble Shooting Information for C7000VP series
Rev. 2.0
Page 112
2010/09/17