E012-1080; E014-0100 - Canon imagePRESS C7000VP Series Trouble Shooting Information

1.3 E012-1080

 Cause
There are some reported instances from the field where E012-0180 occurred because the
primary transfer roller was omitted to pressurize at the time of installation. This caused
insufficient tension to be applied to the ITB belt and a rotational failure of the belt.

1.4 E014-0100

 Description
There are some cases where E014-0100 occurred because the transmission shaft, which is
used in the transmission drive unit in the first fixing assembly lower, was chipped.
- E014-0100 indicates an error of the fixing drive motor (M300) in the first fixing assembly.
20Ｔ Pulley
Ball Bearing
FIRST FIXING ASSEMBLY, LOWER
 Field Remedy
When a similar symptom occurs, inspect the shaft and replace it with a new one if chipping is
confirmed.
Note: Do NOT loosen 2 screws (which fix the transmission drive unit, red circle in the picture)
because the shaft and the gears can be replaced without removing the screws. Be aware of red
marking on them.
FC6-0361-000
FU5-3197-000
XG9-0286-000
Trouble Shooting Information for C7000VP series
Page 7
Timing Belt
Belt Tension Roller
(
Extracts from Parts Catalog FIGURE 816
Separation Drive Shaft
20T Pulley
Ball Bearing
Rev. 2.0
2010/09/17
Transmission Shaft
19T Gear
)
Transmission Shaft
FC6-0361
FC6-0314-000
XF2-1305-280
FU6-0343-000
Belt Tension Roller
Timing Belt
19T Gear