Table of Contents
Advertisement
Mechanical disassemblies
Disassemble should be made following procedures in numerical order.
Following steps show the basic procedures, therefore unnecessary step may be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original otherwise it may cause lose of per-
formance and product safety.
The wiring method of the leads should be returned exactly the same state as the original otherwise it may cause lose
of performance and product safety.
Before Disassemblies :
Turn off a projector and disconnect the AC power cord.
When remove the lens shift unit, shift to the position from which the attachment screw of a lens shift unit and an opti-
cal base can be removed.
1
-1 Cabinet-front-top unit and Cabinet-front-bottom unit removal.
Note :Be careful not to damage Hook. The cabinet-front-top unit is being fixed with cabinet-front-bottom by hook.
1. Remove 2 screws-A.
Push part(a) and pull the Cabinet-front-top unit upward.
2. Remove 4 screws-B and remove the Cabinet-front-bottom unit.
(See Fig.1-1)
Refer to Lens replacement and installation manual.
1
-2 Cabinet-front unit removal.
1. Remove 11 screws and remove the Cabinet-front unit.
(See Fig.1-2)
Hook
B
B
Fig.1-1
A
A
A
A
A
A
- 14 -
A
A
(a)
(a)
B
Cabinet front bottom unit
B
A
A
A
Cabinet front unit
A
A
Fig.1-2
Advertisement
Table of Contents
