Service Personnel Warning - Sanyo PLV-HD10 Service Manual

SERVICE PERSONNEL WARNING

Eye damage may result from directly viewing the light produced by the Lamp used in this equipment. Always
turn off Lamp before opening cover. The Ultraviolet radiation eye protection is required during this servicing.
Never turn the power on without the lamp to avoid electric-shock or damage of the devices since the stabilizer
generates high voltages at its starts.
Since the lamp is very high temperature during units operation. Replacement of the lamp should be done at
least 45 minutes after the power has been turned off, to allow the lamp cool-off.
DO NOT ATTEMPT TO SERVICING THE REMOTE
CONTROL UNIT.
Laser Beam may be leaked out when in disassemble
the Unit. As the Laser Beam used in this Remote
control unit is harmful to the eyes.
Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/Data
Processing Equipment, ANSI/NFPA 75.
Ne puet être utillisé dans une salle d'ordinateurs telle que définie dans la norme ANSI/NFPA 75 Standard for
Protection of Electronic Computer/Data Processing Equipment
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
CAUTION
This product is complied with 21 CFR
This symbol on the rating sheet means the product is Listed by
Underwriters Laboratories Inc. It is designed and manufactured to meet
rigid U.L. safety standards against risk of fire, casualty and hazards.
The CE Mark is a Directive conformity mark of the European Community
(EC).
CAUTION
- 4 -
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LASER-STRAHLING
NICHT IN DEN STRAHL BLICKEN
LASER RADIATION
LASER KLASSE 2
DO NOT STARE INTO BEAM
MAX. OUTPUT: 1mW
WAVE LENGTH: 650 ±20nm
IEC60825-1, Am. 1 1997
CLASS II LASER PRODUCT
MAX OUTPUT (
WAVE LENGTH (
part 1040.10
) : 1 mW
) : 650±20nm