Table of Contents
Advertisement
CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45 minutes
before you open Lamp Cover. Inside of a
projector can become very hot.
CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.
Follow these steps to replace lamp assembly.
1
Check number of lamp to be replaced on Lamp Status
Display.
Turn off a projector and disconnect AC Power Cord.
2
Allow a projector to cool down for at least 45 minutes.
3
Remove two screws on Lamp Cover and press button to
open Lamp Cover. (See right figure.)
4
Loosen two screws and pull out Lamp Assembly to be
replaced by grasping handle.
5
Replace Lamp Assembly with a new one and tighten two
screws. Make sure Lamp is set properly.
6
Replace Lamp Cover and tighten two screws.
Connect AC Power Cord to a projector and turn a
7
projector on.
8
Reset Lamp Replacement Counter. (Refer to section
"Lamp Counter Reset".)
NOTE : Do not reset LAMP REPLACEMENT COUNTER when
lamp is not replaced.
CAUTION :
Do not operate a Projector while any of lamps removed.
It may result in malfunctions, fire hazard, or other accidents.
CAUTION :
High pressure lamp may explode if improperly handled.
Refer to lamp replacement instructions.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replac-
ing all 4 lamps at a time.
LAMP REPLACEMENT
- 11 -
CAUTION
HIGH VOLTAGE
HOT
LAMP
COVER
SCREWS
LAMP1
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 2.
BUTTON
SCREWS
LAMP3
LAMP4
LAMP2
Advertisement
Table of Contents
