Table of Contents
Advertisement
(4) Integrator-lens-out adjustment
SCREW-B
Fig.56a
(5) Condenser-lens adjustment
SCREWS-A
SCREW-B
BOTTOM
SIDE
SLOT-A
SCREW-B
Fig.56b
SCREWS-A
SLOT-B
SLOT-C
Fig.57a
Fig.57b
Before Adjustment :
1. Remove the flexible cables of LCD panels from
the assembly Main. And remove the BGA unit.
And turn on the projector.
2. If the shade appears on the left or right of the
screen, adjust in the following procedure.
Adjustment :
1. Loosen 3 screws-B.
2. Insert a slot screwdriver into slot-A, turn it and
erase shade.
3. Tighten the 3 screws B to fix the integrator lens-
out unit.
Before Adjustment :
1. Remove the flexible cables of LCD panels from the
assembly Main. And remove the BGA unit. Turn on
the projector, follow the procedure of page 84.
2. If the shade appears on the screen, adjust in the
following procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen 4 screws-A.
3. If it appears on the top or bottom.---> Use slot-B.
If it appears on the left or right. -----> Use slot-C.
-- Insert slot screwdriver into each slot, turn it and
erase shade. --
4. Tighten the 4 screws-A to fix the condenser-lens
unit.
- 89 -
Fig.57c
Advertisement
Table of Contents
