Power Consumption; Display Dpm Standby (D-Sub & Hdmi Input); User Control Interface; Hidden Controls - Philips BDL3215E/00 Service Manual

158
158

2.5.2 Power consumption

•
Normal on -
•
•
Standby -
•
Switch off (DC or TACT) -
•
Switch off (AC mains) -
2.5.3 Display DPM standby (D-sub & HDMI input)
DPM-
Recovery from DPM-
Standby-
Recovery from Standby-

2.6 User Control Interface

Via top control keypads or remote control or RS-232.

2.6.1 Hidden Controls

It can't be easily accessed in front of the set.
To be revised according to new graphic sheet/
Key
Power
Vol -
Vol +
Menu
Program -
Program +
•
Power On/off DC switch
•
Access main menu by pressing "MENU" key
•
Select function via "CH+ / CH-"keys, increases / decrease via "VOL+ / VOL-"keys.
•
"VOL+ / VOL-"are also for volume hot key.
32" 115W (typ.), 120W (max.)
42" 210W (typ.), 230W (max.)
< 2W, standby mode; <2W for PC power management
< 1W, RC active
< No power consumption.
The Display enters DPM (sleep) mode when no H&V sync, one of H-sync / V-sync
input or digital clock is absent. "No Signal" message appears before entering DPM
mode. And then, show "Going to Deep Sleep" message for 3 seconds. A delay of 3
seconds before entering the power saving state is required to avoid
misunderstanding of display resolution and timing mode changes.
Power & function recover when both H & V syncs and digital clock are detected.
The Display enters "AV standby mode" when it's switched off by RC.
"Standby/Power" key or SLEEP TIMER function is activated or no AV signal input for
30 minutes.
Power & function recovers when RC "Video Source" or "MENU" is pressed
VOL- VOL+
PC mode
DC switch power standby
Decrease/Volume down
Increase/Volume up/Set
Enter /Exit OSD menu
Menu Select Down
Menu Select Up
MENU CH-
AV mode
DC switch power standby
Decrease/Volume down
Increase/Volume up/Set
Enter /Exit OSD menu
Menu Select Down/Channel Down
Menu Select Up/Channel up
CH+ POWER