Faults - Bellfires Free Bell Installation Instructions And Instructions For Use

Bellfi res
5

FAULTS

Possible reasons for the gas fi re going out are:
• The concentric fl ue system is not installed according to one of the methods detailed
in Paragraph 3.4
• An incorrect "fl ue gas restriction plate" is fi tted.
• The pilot light extinguishes if fumes are not exhausted or are insuffi ciently
exhausted.
• The pilot light is either dirty or defective.
• Insuffi cient gas pressure.
• Thermocouple voltage is too low. This is usually caused by insuffi cient heating of
the thermocouple by the pilot light.
• Dirty electrical contacts in the thermo-electrical system; for example, the
thermocouple connection.
• Batteries in receiver or remote control are fl at.
46 Instructions for use and installation instructions
English