Table of Contents
Advertisement
Bellfi res
3
INSTALLATION INSTRUCTIONS
3.1 GENERAL
The gas fi re must be positioned and connected as a "room sealed system" (balance
fl ue) appliance by a CORGI registered gas installation engineer in accordance with
the following installation instructions, nationally and locally applicable regulations (see
"Technical Details/ Regulations" at the rear of this manual). If you have any queries
regarding the installation, please consult your local gas company.
Important:
Before beginning the installation, check that the details on the
rating plate correspond to the gas type and pressure to which
the appliance will be connected.
The appliance is factory set to the correct tolerances. The pilot light is set to the correct
level of consumption.
It is possible to install the gas fi re with either a wall or roof outlet, using the Barbas
concentric fl ue Ø100 mm (inner) - Ø150 mm (outer) system. The fumes are exhausted
naturally to the outside environment through the inner Ø100 mm pipe whereas the
combustion air supply passes between the Ø100 mm and Ø150 mm pipes.
The gas fi re can be installed in a completely sealed or mechanically ventilated
house without extra ventilation and/or fume extraction.
The appliance is a wall-mounted gas fi re, which can only be installed on a
wall constructed from non-fl ammable material.
When handling the frame, we advise you to use the special gloves supplied, and
to leave them with the owner of the hearth after installation.
If an existing chimney is to be used, please consult your installer fi rst. If the chimney
was previously used for a wood or coal fi re, then it should be cleaned by an expert.
3.2 BARBAS CONCENTRIC FLUE Ø100 MM - Ø150 MM SYSTEM
The appliance is in combination with the concentric fl ue system [Ø100 mm – Ø150 mm]
(either rigid or fl exible) of Barbas compliant with the European CE norm for gas
appliances, and may therefore only be used with this system.
The guarantee is invalidated if the appliance is (completely or partially) installed using a
different system.
The Barbas concentric fl ue [Ø100 mm - Ø150 mm] system can be used with either a
newly-built or existing chimney.
20
Instructions for use and installation instructions
English
Hide quick links:
Advertisement
Table of Contents
