Table of Contents
Advertisement
OnLine Power
THIS EQUIPMENT CONTAINS CIRCUITS THAT ARE ENERGIZED WITH HIGH
VOLTAGES. ONLY TEST EQUIPMENT DESIGNED FOR TROUBLESHOOTING
HIGH VOLTAGES SHOULD BE USED, PARTICULARLY FOR OSCILLOSCOPES
AND PROBES.
ALWAYS CHECK WITH AN AC AND DC VOLTMETER TO ENSURE SAFETY
BEFORE INITIATING CONTACT OR USING TOOLS. EVEN WHEN THE POWER
IS OFF, DANGEROUSLY HIGH POTENTIAL VOLTAGES MAY EXIST AT
CAPACITOR BANKS. ALWAYS OBSERVE BATTERY PRECAUTIONS WHEN
OPERATING NEAR ANY BATTERIES.
FAILURE TO OBSERVE THESE PRECAUTIONS COULD RESULT IN DEATH,
INJURY OR DAMAGE TO EQUIPMENT.
OBSERVE ALL BATTERY SAFETY PRECAUTIONS DURING INSTALLATION
OR SERVICE OF THE UPS OR BATTERIES.
CIRCUIT
ELECTROCUTION MAY STILL BE PRESENT. THE BATTERY POWER TO THE
UNIT MUST BE LOCKED AND TAGGED "OFF" BEFORE PERFORMING ANY
SERVICE OR WORK ON THE UNIT.
SAFETY INFORMATION AND MATERIAL SAFETY DATA SHEET IS LOCATED
IN A POCKET ATTACHED TO THE INSIDE OF LEFT DOOR OF EACH UPS.
FAILURE TO FOLLOW THOSE INSTRUCTIONS AND THE INSTRUCTION
LISTED ABOVE AND ELSEWHERE IN THIS MANUAL COULD RESULT IN AN
EXPLOSION, FIRE, EQUIPMENT FAILURE, OR ELECTROCUTION.
BE CONSTANTLY AWARE THAT THE UPS SYSTEM CONTAINS HIGH DC AS
WELL AS AC VOLTAGES. WITH INPUT POWER OFF AND THE BATTERY,
DISCONNECTED, HIGH VOLTAGE AT THE FILTER CAPACITORS AND POWER
CIRCUITS SHOULD DISCHARGE WITHIN 30 SECONDS. HOWEVER, POWER
CIRCUIT FAILURES CAN OCCUR, SO YOU SHOULD ALWAYS ASSUME THAT
HIGH VOLTAGE MIGHT STILL EXIST AFTER SHUTDOWN.
POWER IS OFF USING AC AND DC VOLTMETERS BEFORE MAKING
CONTACT.
BREAKER
IN
Danger!
Danger!
THE
OFF
POSITION,
THE BATTERY MANUFACTURER'S
Danger!
5-2
EVEN WITH THE BATTERY
THE
DANGER
VERIFY THAT
OF
Advertisement
Table of Contents
