Table of Contents
Advertisement
OnLine Power
ALL POWER CONNECTIONS MUST BE COMPLETED BY A LICENSED
ELECTRICIAN WHO IS EXPERIENCED IN WIRING THIS TYPE OF EQUIPMENT.
WIRING MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE
NATIONAL AND LOCAL ELECTRICAL CODES.
CAUSE DAMAGE TO THE EQUIPMENTS, INJURY OR DEATH OF PERSONNEL.
VERIFY THAT ALL HIGH AND LOW VOLTAGE INPUT POWER CIRCUITS ARE
DE-ENERGIZED AND LOCKED OUT BEFORE INSTALLING CABLES OR
MAKING ANY ELECTRICAL CONNECTIONS.
EXERCISE EXTREME CARE WHEN HANDLING UPS AND BATTERY
CABINETS TO AVOID EQUIPMENT DAMAGE OR INJURY TO PERSONNEL.
CABINETS WEIGH SEVERAL HUNDRED POUNDS.
TEST LIFT AND BALANCE THE CABINETS BEFORE MOVING.
MINIMUM TILT FROM VERTICAL AT ALL TIMES. THE BOTTOM STRUCTURE
WILL SUPPORT THE UNIT ONLY
COMPLETELY UNDERNEATH THE UNIT.
OBSERVE ALL BATTERY SAFETY PRECAUTIONS DURING INSTALLATION
OR SERVICE OF THE UPS OR BATTERIES.
CIRCUIT
ELECTROCUTION MAY STILL BE PRESENT. THE BATTERY POWER TO THE
UNIT MUST BE LOCKED AND TAGGED "OFF" BEFORE PERFORMING ANY
SERVICE OR WORK ON THE UNIT.
SAFETY INFORMATION AND MATERIAL SAFETY DATA SHEET IS LOCATED
IN A POCKET ATTACHED TO THE INSIDE OF LEFT DOOR OF EACH UPS.
FAILURE TO FOLLOW THOSE INSTRUCTIONS AND THE INSTRUCTION
LISTED ABOVE AND ELSEWHERE IN THIS MANUAL COULD RESULT IN AN
EXPLOSION, FIRE, EQUIPMENT FAILURE, OR ELECTROCUTION.
BREAKER
IN
Danger!
Danger!
Danger!
IF THE FORKLIFT
Danger!
THE
OFF
POSITION,
THE BATTERY MANUFACTURER'S
1-2
IMPROPER WIRING MAY
FORKS ARE
EVEN WITH THE BATTERY
THE
DANGER
MAINTAIN
OF
Advertisement
Table of Contents
