Set Alarm; Display Software Version - Bush LATITUDE SERIES Manual

LATITUDE SERIES
Troubleshooting and Technical Specification

Set Alarm


Note: Ensure that the time is set correctly before you set one of the Alarms.
The process to set an alarm is as follows:
1. Press the MENU Button < System >  < Alarms >.
2. Press the SELECT dial to confirm, and your radio will display 'Alarm 1 Setup'. To set alarm2,
dial to then press the SELECT dial to select 'Alarm 2 Setup'.
3. Once you have selected the alarm
to configure the following parameters. Once each is set, press the SELECT dial:

Alarm State: Off/ On, press the

On Time: 00: 00 (alarm sounding time) Select the alarm time in hours, then minutes. Press the SELECT dial
to confirm each once confirmed.

Duration time: 15/30/45/60/90minutes (alarm sounding lasting time) Select how long you wish for the alarm
to sound for.

Source: Buzzer/DAB/FM Select the audio that you wish to hear when the alarm sounds.
Alarm Frequency: Daily, Once, Weekends or Weekdays. Selects how often you wish for the alarm to sound.


Alarm Volume: Press the
to confirm.
Once all parameters are confirmed your radio will display 'Alarm saved'.
To Operate SNOOZE

When the Alarm sounds and you wish to activate the snooze function press the SELECT dial.

The radio will go into Standby mode for a period of 5 minutes. It will display a five minute count down and
once the 5 minutes is over, the alarm will sound again.

The Alarm will sound again after the snooze time has elapsed, at this time, if you press the SNOOZE button
again and it will count down for another 5 minutes, or you also can press the POWER button to stop the
alarm.
To Turn Off Alarm

Note: To turn the alarm off temporarily, when the alarm sounds, press the POWER button. To turn it off permanently, follow
the instructions 1 and 2 for setting an alarm as outlined above, and select Off.
Refer to steps1 and 2 outlined above. Use the
confirm.

Display Software Version

1. Press the MENU Button < System >  < SW version >.
2. Press the SELECT dial to confirm. You will now be able to view the software information of this radio.

Press the SELECT dial twice, then follow the instructions on the display
or buttons to select On or Off.
or button to select your desired alarm volume, then press the SELECT dial
or Button to select 'Off', and then press the SELECT dial to
12
.
t
urn the SELECT