Table of Contents
Advertisement
Using your Stereo DAB/FM Radio
Let's get started
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to 'Add new device' , if necessary.
Note: Some products will automatically search for a new device and so the 'Add new
device' option is not available.
4. When found, your radio will be displayed as 'BUSH BD-1807' . Select the device name
to begin pairing.
5. When pairing is complete 'Connected' will be displayed and there will also be an audio
confirmation.
6. Now that you have paired your device with the radio, it will connect to it when it is
within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the radio unless you decide to disconnect or
'unpair' it.
Note: You can long press the Scan button for 3 seconds to unpair your current device
and search for new devices.
Listening to Music/Audio using Bluetooth
In Bluetooth mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the radio speakers. Adjust the volume on the
connected device and/or your radio.
2. You can use the controls on your paired Bluetooth device as well as those on your
radio.
Controls available on your radio:
•
Play/Pause - Short press the Scan button to play/pause.
•
Skip back: - Turn the Tune/Select control anti-clockwise to skip back to the previous
track.
30
Using your Stereo DAB/FM Radio with Bluetooth
Using your Stereo DAB/FM Radio
Let's get started
•
Skip forward: - Tune the Tune/Select control clockwise to skip forward to the next
track.
Note: If you do not use your radio for approximately 30 minutes and no audio signal is
received, it will automatically go to Standby mode, or Power off when using batteries.
Setting the alarm
Note: Check that the radio has the correct time and date before you set an alarm.
1. Long press the Alarm button.
2. Alarm 1 Setup is displayed (use the Tune/Select control to move to Alarm 2, if required).
Short press the Tune/Select control.
3. Alarm 1 Wizard On time is displayed and the hour digits for the alarm will flash.
4. Use the Tune/Select control to scroll to the hour for the alarm and press to Select.
5. The minutes will now flash. Use the Tune/Select control to scroll to the minutes for
the alarm and press to Select. The duration time will now flash.
6. Use the Tune/Select control to scroll to the duration for the alarm and press to Select.
You can choose from 15, 30, 45, 60, 90 and 120 minutes. Press the Tune/Select
control to Select. The source for the alarm will now flash.
7. Use the Tune/Select control to scroll to the sound source for the alarm. You can
choose from Buzzer, DAB or FM. Press to Select.
Note: If you select DAB or FM radio for the alarm source, 'Last listened' will flash in the
display. Short press the Tune/Select control and the last listened to radio station in DAB
or FM, as appropriate, will be used for your alarm.
8. Use the Tune/Select control to scroll to the frequency for the alarm. You can choose
from Daily, Once, Weekends or Weekdays. Press to Select.
Note: If you select 'Once' , you will then be prompted to set the date for your alarm.
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
Using your Stereo DAB/FM Radio with Bluetooth
31
Advertisement
Table of Contents
