Using The Radio - Programmed Station Function; Setting And Using The Alarm - Bush Classic BRC-3 Instruction Manual

Using your DAB/FM Radio
Let's get started
USING THE RADIO -
PROGRAMMED STATION FUNCTION
This function allows up to 10 stations to be programmed into the memory and stored in DAB and
FM modes.
1. Follow the directions above to select a radio station.
2. Press and hold the PRESET button until the display shows a 'save to P#' (fig.11).
3. Turn the SCROLL knob to select the preset storage location and then press the SELECT button
to confirm. The station now broadcasting has now been stored in the selected location (fig.12).
4. Repeat the above steps to store further stations.
fig.10
5. To listen to the preset stations, press the PRESET button briefly and then use the SCROLL knob
and the SELECT button to select the desired location. The station name or frequency and
preset location number will be displayed (fig.13) in the lower half of the display or if the preset
has not been allocated, 'Preset empty' will be shown.
Notes:
∞ If the unit is disconnected from the mains supply for any length of time and batteries are not
installed; the programmed stations will be lost.
∞ Each of the above steps need to be completed within 5 seconds of pressing the button,
otherwise the screen will clear.

SETTING AND USING THE ALARM

This unit has a dual alarm function.
SETTING THE ALARM (in operational mode only)
1. Press the ALARM / SNOOZE button to enter the alarm menu, press the
button ONCE to display 'Alarm 1 set up' (fig. 14) and press the button
TWICE to display 'Alarm 2 set up' . Press the SELECT button to accept
alarm of choice.
2. After selecting the alarm of choice, the hour digits will flash in the
display. Turn the SCROLL knob to select the correct alarm wake up
hour and press the SELECT button to confirm. The minute digits will start to flash.
3. Turn the SCROLL knob to select the correct alarm minute and press the SELECT button to
confirm. The alarm duration will be displayed.
fig.12 fig.13
fig.14
21