Digital Watchdog DW-716 DW-709 Operating Instructions Manual page 63

7.4.2 Motion Detection
[Figure 7-36. Motion Detection]
[Figure 7-37. Motion-detection setting]
[Motion link setting]
• You can set a motion-link recording for each camera.
• When the camera detects movement in the motion-detection area, the linked camera will begin recording as well, regardless of its
recording schedule.
• To use Motion-link recording, the camera detecting the movement must be set to Motion-Detection recording in the schedule. If the
camera's schedule is set to Continuous Recording, Motion Link will be disabled.
• In Surveillance mode, when the camera detects movement in its motion-detection area, the linked camera channel will flash 'REC' and
begin recording.
• In [Motion Detection] menu, you can set motion detection
area, set motion sensitivity, and enable or disable alert sound.
[Setting Motion Detection]
• To set Motion Detection area, highlight a block of the area of
the channel screen by using the directional keys, then press
Enter key to select the block.
• The channel screen is divided into 48 blocks. You can select
any and as much blocks as you wish.
[Sensitivity]
• You can set the motion-detection sensitivity of each camera
to "LOWEST", "LOW", "NORMAL", "HIGH", or "HIGHEST".
[Full Motion]
• To set the whole channel screen to motion-detection area,
switch the [Full Motion] option to "ON". To cancel the whole
screen from motion-detection area, switch the option to
"OFF".
[Beep]
• To hear a 'beep' warning sound when the system detects
movement in motion-detection area, set the [Beep] option to
"ON". To hear no warning sound, set the option to "OFF".
[Camera]
Use the jog/shuttle on the system to select the camera for
changing its options.
[OK]
• Press [OK] button to accept any changes made and return
to Setup menu
KALTECH DW716 Manual
KALTECH DW716 Manual
63
63