Asus MAXIMUS VII IMPACT User Manual page 109

GPU.DIMM Post
The GPU.DIMM Post automatically detects and displays the information about the devices or
memory installed on the PCIe and DIMM slots. The field shows N/A if there are no devices
installed on the slots.
External DIGI+ Power Control
CPU Load-Line Calibration [Auto]
Load-line is defined by Intel® VRM specification and affects CPU power voltage. The
CPU working voltage will decrease proportionally to CPU loading. Higher load-line
calibration could get higher voltage and good overclocking performance but increases
the CPU and VRM thermal conditions.
Select from Level 1 to Level 9 to adjust CPU power voltage from 0% to 100%.
The actual performance boost may vary depending on your CPU specification.
DO NOT remove the thermal module. The thermal conditions must be monitored.
CPU VRM Switching Frequency [Auto]
This item affects the VRM transient response speed and the component thermal
production. Select [Manual] to configure a higher frequency for a quicker transient
response speed.
Configuration options: [Auto] [Manual]
DO NOT remove the thermal module. The thermal conditions should be monitored.
The following item appears only when you set the CPU VRM Switching Frequency to
[Manual].
Fixed CPU VRM Switching Frequency (KHz) [300]
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> or <-> to adjust the value. The values range
from 300 KHz to 500 KHz with an interval of 50 KHz.
Do not remove the thermal module when the manual mode is selected. The thermal
conditions should be monitored.
The following item appears only when the CPU VRM Switching Frequency is set to [Auto].
VRM Spread Spectrum [Disabled]
This item allows to enhance the system stability.
Configuration options: [Disabled] [Enabled]
ASUS MAXIMUS VII IMPACT
3-23