Table of Contents
Advertisement
AXIS Q8414-LVS Network Camera
Events
-
Day/Night Mode – Trigger the rule when the product switches between day mode (IR cut filter on) and night
mode (IR cut filter off). This can for example be used to control an external infrared (IR) light connected
to an output port.
-
Motion Detection – Trigger the rule when motion is detected. See Motion Detection on page 32.
-
Tampering – Trigger the rule when tampering is detected. See Camera Tampering on page 32.
•
Hardware
-
Network – Trigger the rule if network connection is lost or restored. This can for example be used to start
recording to the SD card.
-
Temperature – Trigger the rule if the temperature falls outside or inside the operating range of the product. This
can for example be used to send maintenance notifications.
•
Input Signal
-
Digital Input Port – Trigger the rule when an I/O port receives a signal from a connected device. See I/O
Ports on page 52.
-
Manual Trigger – Trigger the rule using the Manual Trigger button in the Live View page. See Controls on
the Live View Page on page 11 . This can for example be used to validate actions during product installation
and configuration.
•
PTZ
-
Moving – Trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
-
Preset Reached – Trigger the rule when the camera stops at a preset position. This can be for example be used
with the Send Images action to upload images from the preset position.
•
Storage
-
Available – Trigger the rule when the storage device is unmounted or removed. This can for example be used to
send maintenance notifications.
-
Full – Trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
overwritten to prevent the storage device from becoming full.
-
Locked – Trigger the rule if the storage device is locked (write protected).
•
System
-
System Initializing – Trigger the rule when the product is being started. This can for example be used to send a
notification when the product restarts.
•
Time
-
Recurrence – Trigger the rule periodically. See Set Up Recurrences on page 40. This can for example be used to
upload an image every 5 minutes.
-
Use Schedule – Trigger the rule according to the selected schedule. See Create Schedules on page 40.
Actions
Available actions include:
•
IR Illumination – Activate or deactivate IR light.
•
Day/Night Vision Mode – Set day mode (IR cut filter on) or night mode (IR cut filter off).
•
Output Port – Activate an I/O port to control an external device.
38
Advertisement
Table of Contents
