Table of Contents
Advertisement
Troubleshooting
Problem
• Relocate the display unit and/or the 5-in-1
sensor. The units must be within 330ft
(100m) of each other.
• Make sure both units are placed at least 3
feet (.9m) away from electronics that may
interfere with the wireless communication
(such as TVs, microwaves, computers, etc).
• Use standard alkaline batteries (or lithium
batteries in sensor when temperature is
below -4ºF/-20ºC). Do not use heavy duty
No outdoor sensor
or rechargeable batteries. NOTE: It may
reception
take up to 20 minutes for display unit and
sensor to synchronize after batteries are
replaced.
no bars
• Synchronize the units:
1. Bring both the sensor and display unit
indoors and remove at least one battery
from each.
2. Reinstall the battery in the outdoor
sensor.
3. Reinstall battery into the display unit.
4. Let the units sit within a couple feet of
each other for about 20 minutes to gain a
strong connection.
Flashing of the outdoor temperature may be an
indication of wireless interference.
Outdoor
• Make sure the A-B-C switch in the battery
temperature
compartments of both the display unit and
is flashing or
sensor are switched to the same letter. You may
showing dashes
choose A, B or C; but both units must match for
successful synchronization. Sometimes changing
to a different channel can help.
• Check that the batteries are installed
correctly. Batteries may need to be
replaced.
Display screen
• Reset the display by pressing the reset
not working
button, located on the back of the display
unit. Date and time will need to be entered
after a reset.
• The Weather Forecast icon is a prediction
Inaccurate forecast
of conditions for the next 12 to 24 hours. It
(Continued on p.15)
is not showing current conditions.
Possible Solution
14
Display Unit Setup
1
1. Install or Replace Batteries
1. Slide off the battery
compartment cover.
2. Insert 3 x AA alkaline batteries
into the battery compartment,
as shown. Follow the polarity
(+/-) diagram in the battery
compartment.
3. Replace the battery cover.
A-B-C Switch
A B C
2
set to match
sensor
Install Batteries
1
3 AA batteries
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2
3. Set the A-B-C Switch
Locate the A-B-C switch inside the
battery compartment. Set the A-B-C
switch to A, B or C. You must select
the same letter choices for both the
display unit and the sensor in order
for the units to synchronize.
7
Advertisement
Table of Contents
