Setup; 5-In-1 Sensor Setup - ACU-RITE 1502 Instruction Manual

SETUP

5-in-1 Sensor Setup

1
1. Install or Replace Batteries
Batteries MUST be installed for this
product to operate. AcuRite
recommends high quality alkaline or
lithium batteries for the best product
performance. Heavy duty or
rechargeable batteries are not
recommended.
The 5-in-1 sensor requires lithium
batteries in low temperature
conditions. Cold temperatures can
cause alkaline batteries to function
improperly. Use lithium batteries in the
5-in-1 sensor for temperatures below
-4ºF / -20ºC.
1. Slide off the battery compartment
cover.
2. Insert 4 x AA batteries into the
battery compartment, as shown.
A B C
A-B-C Switch
3
set to match
display unit
Install Batteries
1
4 AA batteries
Follow the polarity (+/-) diagram in
the battery compartment.
3. Replace the battery cover.
2
2. Remove Rain Gauge Stabilizer
Locate and remove the rain gauge
stabilizer (plastic tab) taped into the
bottom of the sensor. The rain gauge
will not function until this is removed.
3
3. Set the A-B-C Switch
Locate the A-B-C switch inside the
battery compartment. Set the A-B-C
switch to A, B or C. You must select
the same letter choices for both the
sensor and the display unit in order
for the units to synchronize.
Rain Gauge Stabilizer
2
Remove and discard
NOTE: Screws by rain collector
are typicaly set at different
heights. Do not adjust unless
calibrating the rain gauge.
6
Troubleshooting
Problem
• Has Learning Mode icon disappeared from
the display unit? Learning Mode must be
completed before the forecast and pressure
will be accurate.
• Allow the unit to run continuously for 33
Inaccurate forecast
days. Battery removal or resetting the
(Continued from p.14)
display unit restarts Learning Mode. After
14 days, forecast should be fairly accurate,
however Learning Mode continues to
calibrate for a total of 33 days.
• Make sure both the display unit and 5-in-1
sensor are placed away from any heat
sources or vents (see page 10 ).
• Make sure both units are positioned away
Inaccurate
from moisture sources (see page 10 ).
temperature or
• Make sure 5-in-1 sensor is mounted at least
humidity
5ft off of the ground.
• Calibrate indoor and outdoor temperature
and humidity (see page 16).
• Check to ensure the rain gauge stabilizer
(plastic tab) has been removed from the
bottom of the sensor (see page 6).
No rainfall
• Clear debris, such as leaves, out of the rain
collector funnel and debris screen.
• See Calibrate the Rain Gauge on page 17.
• What is wind reading being compared to?
Pro weather stations are typically mounted
at 30ft high or more. Make sure to
compare data using a sensor positioned at
the same mounting height.
Inaccurate wind
• Check location of the sensor. Ensure itʼs
readings
mounted a minimum of 5ft in the air with no
obstructions around it (within several feet).
•Ensure wind cups are spinning freely. If they
hesitate or stop try lubricating with
graphite powder or spray lubricant.
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
Possible Solution
15