Input/Output; Internal Gps Setup Menu; Fish Finder Transmission; Autopilot Connection - VDO MAP 7w Plus GPS User Manual

turn from "Off" to "On" for making visible these functions in the chart plotter
menus, and then for using in the chart plotter handling.
4.7

INPUT/OUTPUT

After a software upgrade the RAM is cleared and then the chart plotter starts
with the default settings. Then you have to go into the Input/Output menu and
set again the proper input format.
MAP 7wi Plus GPS/MAP 7cwi Plus GPS:

Internal GPS Setup Menu

[MENU] + [MENU] + "INPUT/OUTPUT" + [ENTER] + "INTERNAL GPS SETUP"
+ [ENTER]
Internal GPS
Restart GPS
E
Diff Correction Source
Navigation Speed
E
MAP 7cwi Plus GPS:

Fish Finder Transmission

The Fish Finder embedded is connected directly to the Port 2. To switch the inter-
nal Fish Finder transmission On/Off follow the procedure:
[MENU] + [MENU] + "INPUT/OUTPUT" + [ENTER] + "FISH FINDER ON/
STANDBY" + [ENTER]

Autopilot Connection

Connect the Autopilot to the serial Port n:
[MENU] + [MENU] + "INPUT/OUTPUT" + [ENTER] + "PORT n OUTPUT" +
[ENTER]. Then choose your preferred setting among the NMEA available
settings NMEA 0183 4800-N81-N, NMEA 0180, NMEA 0180/CDX) and press
[ENTER] to confirm.
Where:
n = 1/2/3 for MAP 11csE Plus GPS
n = 1/4/5 for MAP 7cwi Plus GPS
n = 1/2/4/5 for MAP 7wi Plus GPS
n = 1/2/3/4/5 for MAP 7w Plus GPS/MAP CX Plus

External NMEA Connection

Connect the External NMEA to the serial Port n:
[MENU] + [MENU] + "INPUT/OUTPUT" + [ENTER] + "PORT n INPUT"
+ [ENTER]. Then choose your preferred setting and press [ENTER] to confirm.
Where:
n = 1/2/3 for MAP 11csE Plus GPS
n = 1/4/5 for MAP 7cwi Plus GPS
n = 1/2/4/5 for MAP 7wi Plus GPS
n = 1/2/3/4/5 for MAP 7w Plus GPS/MAP CX Plus

C-COM GSM PLUS Connection

To connect the modem C-COM to the chart plotter follow the procedure:
54
WARNING
: Enables (On) or disables (Off) the Internal GPS.
: Restarts all GPS processes. Once executed, the message "Done" is shown.
: Sets what kind of Differential Correction will be used by the GPS between WAAS/EGNOS
and RTCM-104 (beacon correction).
: Sets the Navigation Speed among 0.1 Kts (low speed, for marine/pedestrian application),
0.9 Kts (medium speed, for marine application) and 3.0 Kts (high speed, for car
application).
E
E
E
User Manual