Selecting The Chart Language; Using C-Map B; Simulation Mode; Y Jeppesen Data C-Card - VDO MAP 7w Plus GPS User Manual

don't be able to reselect your language (the above procedure is not of help
to you), follow this procedure: press [MENU] two times, move the cursor to
highlight the first item (starting from the top) which corresponds to the
Configurations menu and press [ENTER]. Then a window appears with
"Language" message, press [ENTER]; now select your language and press
[ENTER] again. Anyway if you in trouble, see Chapter 6 "Maintenance" for
a RAM Clear operation: the chart plotter will also return all selections, in
particular language, to original default values.
2.4

SELECTING THE CHART LANGUAGE

[MENU] + [MENU] + "CONFIGURATIONS" + [ENTER] + "CHART LANGUAGE"
+ [ENTER] + select the language you want + [ENTER]
The possible choices are listed in the table below:
Language: Allows setting the language to display chart information. The language is chosen among the list
of languages available on the cartographic data (C-CARD or embedded charts).
Mode: Defines how objects are translated. It is possible to choose between the three following options:
NOTE a. When User Interface Language is changed, Chart Language settings are set
as follows: MODE is set to Off and Chart Language is set as the User
Interface Language selection if available on the chart data, otherwise is set
to English.
b. If the cartographic data is changed (for example the C-CARD is removed
or replaced), Chart Language settings should be verified and if necessary
changed.
2.5

USING C-MAP B

The chart plotter has a built-in world map. To use the chart plotter as a navigation
aid, data C-CARD with detailed information for the area you wish to navigate are
required. See the technical details of your chart plotter for inserting/removing data
C-CARD procedure.
NOTE During normal operations the data C-CARD should not be removed since the
chart plotter may lock up.
2.6

SIMULATION MODE

The built-in Simulator function allows you to become proficient in the use of the
chart plotter. It simulates the reception of the navigation data (Lat/Lon, Course,
Speed, Date, Time). The simulated ship's position is placed at the current cursor
position by the time the simulation is activated. To start the Simulator:
Place the cursor at your desired position + [MENU] + [MENU] + "ADVANCED
SETTINGS" + [ENTER] + "SIMULATION" + [ENTER] + "ACTIVATE SIMULA-
TION" + [ENTER] + "ON" + [ENTER]
You might insert the Speed, Heading, Date and Time values:
[MENU] + [MENU] + "ADVANCED SETTINGS" + [ENTER] + "SIMULATION" +
[ENTER] + "SPEED"/"HEADING"/"DATE"/"TIME" + [ENTER] + enter values
+ [ENTER]
Also in Chart page you might use the cursor up/down to adjust the Speed and the
cursor left/right to adjust the Course. To enable this Cursor Control
follow this procedure:
[MENU] + [MENU] + "ADVANCED SETTINGS" + [ENTER] + "SIMULATION"
+ [ENTER] + "CURSOR CONTROL" + [ENTER] + "ON" + [ENTER]
20
Off Uses the same Language used for LANGUAGE. If the selected language is
not present on the objects information, English is used instead;
English Always uses English;
Local Uses the first Local language present on data. If no Local language is
available, English is used instead.
J
Y EPPESEN
E
DATA C-CARD
function
E
User Manual