Audible Alarm; Grounding Alarm; Grounding Alarm Range; Grounding Alarm Report - VDO MAP 7w Plus GPS User Manual

[MENU] + [MENU] + "ALARMS" + [ENTER] + "DEPTH ALARM" + [ENTER]

Audible Alarm

To enable (On) or disable (Off) the Audible Alarm.
[MENU] + [MENU] + "ALARMS" + [ENTER] + "AUDIBLE ALARM" + [ENTER]

Grounding Alarm

To verify potential danger to navigation such shallow water (depth areas), inter-
tidal areas, land, rocks, obstructions and shoreline constructions. The maps are
scanned every 10 seconds.
If any of the above objects are found, the chart plotter notifies the danger on a
dedicated warning message box. The active "Grounding Alarms" are shown in the
Grounding Alarm Report page.
To activate the Grounding Alarm:
[MENU] + [MENU] + "ALARMS" + [ENTER] + "GROUNDING ALARM" +
[ENTER]
The chart plotter scans a sector in front of the boat. The direction is determined
by the current boat heading. You can select the length and its angle is 30 degrees.
The Grounding Alarm is switched Off by default after a Master Reset.

Grounding Alarm Range

To set the length of the sector to be detected among 0.25, 0.5, 1.0 Nm.
[MENU] + [MENU] + "ALARMS" + [ENTER] + "GROUNDING ALARM RANGE"
+ [ENTER]

Grounding Alarm Report

To display the report of the dangerous objects currently detected.
[MENU] + [MENU] + "ALARMS" + [ENTER] + "GROUNDING ALARM REPORT"
+ [ENTER]
When any of the searched objects is found in the scanned area, a tick marker is
printed on the relative box to identify which dangerous objects have been cur-
rently detected. Once the alarm condition is no longer present, the relative tick
marker is removed.
NOTE The alarm "No data" is shown when no specific cartographic data are found
on the C-CARD or when no C-CARD is inserted.
MAP 11csE Plus GPS/MAP cX Plus GPS:

External Alarm

When any alarm condition occurs the pin is switched from High Impedance to
ground. This signal can be used by an external device (as a hooter or buzzer).
[MENU] + [MENU] + "ALARMS" + [ENTER] + "EXTERNAL ALARM" + [ENTER]
3.9

USER C-CARD

The chart plotter allows to back up Marks, Routes and Tracks to a User C-CARD.
You can also restore the data to internal memory at a later time. This allows
virtually unlimited storage. The User C-CARD data storage is organized as a file
system.

User C-CARD page

To display the content of a User C-CARD inserted into the C-CARD slot of your
chart plotter:
[MENU] + [MENU] + "USER C-CARD" + [ENTER]
User Manual
E
39