Samsung SHR-2160 User Manual page 16

SHR-2160/2162/2080/2082 USER'S MANUAL
5. When mounting an additional HDD, the primary master has to be mounted.
In general, HDD should be installed as the primary master of IDE, and the CD-RW drive
should be installed as the secondary master of IDE.
Mount the HDD you want to add after setting the master/slave jumpers in the proper order.
When adding one - Primary slave (mount on
the top of the bracket that
has a built-in HDD when
coming out of factory.)
Mount the HDD to the bracket-HDD with (A)SCREW-SPECIAL (BWH,6-32UNC,L10.5) and
(B)SCREW-TAPTITE (BH,+,S,M3,L6,ZPC) (4 spots) that was provided as an accessory.
(The screws have to be tightened so that it doesn't vibrate loose.)
(B)SCREW-MACHINE is provided when purchasing the HDD.
6. Re-mount built-in HDD bracket-HDD to the place where it was separated from. Place the
bracket-HDD (A) so that all the five mounting spots on the bottom and the bracket-HDD's
mounting holes are perfectly aligned, then slide it toward the outside of the product and
tighten the screws. For the bracket-HDD (B), place it so that all the four mounting spots on
the bottom and the bracket-HDD's mounting holes are perfectly aligned, then tighten the
screws.)
2-13
When adding two - Secondary Slave (mount
to the upper bracket of the
built-in CD-RW.)
7. Make sure that the bracket-HDD is mounted stably inside of the product, then connect the
power supply cable, signal transmission cable (IDE cable), and fan cable to the HDD.
2-14