Fixed Station Operation - Kenwood TM-V708A Instruction Manual

■

Fixed Station Operation

In order to use this transceiver for fixed station
1
operation, you will need a separate 13.8 V DC power
supply (purchased separately). We recommend
using a power supply with a current capacity of 12 A.
Note:
◆
To get the most out of your transceiver, we recommend using
the optional PS-33 (20.5 A, 25% duty cycle) power supply.
◆
Before connecting the DC power supply to the transceiver, be
sure to switch the transceiver and the DC power supply OFF.
◆
Do not plug the DC power supply into an AC outlet until you
make all connections.
1 Connect the DC power cable to the regulated DC
power supply and check that the polarities are
correct (Red: positive, Black: negative).
• Do not directly connect the transceiver to an AC
outlet. Use the supplied DC power cable to connect
the transceiver to a regulated power supply.
• Do not substitute the cable with smaller gauge wires.
Fuse holder
Red (+)
Black (–)
6
Regulated DC power
supply
To AC outlet
2 Connect the DC power cable to the transceiver's
power supply connector.
• Press the connectors firmly together until the locking
tab clicks.
Fuse holder