Table of Contents
Advertisement
■
Using Visual Scan
1 Select your desired band.
2 Turn the Tuning control, or press Mic [UP]/
[DWN], to select the operating frequency.
• This frequency will be used as the center frequency.
3 Press [F], [VISUAL] to start Visual Scan.
9
• To halt Scan, press [PAUSE]. "PAUSE" appears and
blinks. Press [PAUSE] again to resume.
4 To change the operating frequency, turn the
Tuning control or press Mic [UP]/ [DWN].
• The displayed frequency changes and the cursor
moves.
• Press [SET] to use the changed operating frequency
as the center frequency.
• Press [RESET] to restore the previous operating
frequency.
5 To exit Visual Scan, press [ESC].
46
Note:
◆
If you start Visual Scan in Memory Recall mode, the memory
channel frequencies will be scanned.
◆
If you start Visual Scan after recalling the Call channel, the
Call channel frequency will be used as the center frequency.
◆
If the frequency range specified for Program Scan or Program
VFO is narrower than the range specified for Visual Scan, the
range for Program Scan or VFO will be used for Visual Scan.
◆
Visual Scan stops while transmitting.
◆
Starting Visual Scan switches Automatic Band Change OFF.
◆
If you start Visual Scan in one of the following conditions, you
cannot receive in the current operating frequency. To use this
frequency, press [PAUSE] to halt Scan.
•
Memory Recall or Call Channel mode
•
A frequency in the 118, 220, or 1200 MHz band was
selected in VFO mode.
◆
Depending on the transceiver conditions, Visual Scan and the
conventional S-meter may indicate different signal strength
levels.
Advertisement
Table of Contents
