Accessories; Before Operation - Kenwood TH-78A Instruction Manual

ACCESSORIES

Antenna . . . . . . . . . . . . . . . . . . . . . . .
Belt Hook . . . . . . . . . . . . . . . . . . . . . .
Hand Strap . . . . . . . . . . . . . , . . . . . .
Rubber Cap . . . . . . . . . . . . . . . . . . . .
AC plug (M type only) . . . . . . . . . . . . . E19-0254- X X
Battery Case (TH-78Q type only) . . . A02-1658-X X
NiCd Battery Pack(PB-13) . . . . . . . . . W09-0563-X X
Battery Charger(BC-14)
for U.S.A. and Canada (12OV)
. . . . . . . . . . . . . . . . . . . . . . . W09-0568- X X
for Oceania (240V)
for other market (120/240V)
. . . . . . . . . . . . . . . . . . . . . . . W09-0566- X X
Instruction Manual . . . . . . . . . . . . . . .
Warranty Card(U.S.A.,Canada,and Europe)
Note
Your transceiver comes with a portable dual-band
flex antenna. For fixed transceiver locations, we
recommend that you use a more permanent
antenna installation to help eliminate interference
and improve performance.

BEFORE OPERATION

T90-0444-X X
Thank you for purchasing this KENWOOD
J29-0465-X X
transceiver. To get the most out of its many features,
J69-0312- X X
we suggest you read this instruction manual
B09-0330- X X
carefully, and keep it handy for further reference.
To get ready to transmit and receive.
1 Check the accessories list to be sure everything you
need has been included in the package.
2 Charge the included NiCd battery pack, following the
W09-0565- X X
instructions completely before proceeding. (See page 8)
W09-0569- X X
When you have everything checked out and charged,
you're ready to get to the Receiver Operation section
and get up and running with your new equipment.
Other sections follow in a logical order to help you
W09-0567- X X
learn and use this transceiver to its full potential.
B62-0248-X X
minute of transmission and 3 minutes of reception.
Longer transmissions or extended operation in the
HI power mode may cause the back of the
transceiver where the heat sink (rear panel) might
come in contact with plastic or vinyl surfaces.
CAUT/ON
The recommended transceiver duty cycle is 1
transceiver to get warm. Do not place the