Chapter 4 Operating Basics; Switching The Power On/Off; Adjusting The Volume; Selecting A Band - Kenwood TM-V708A Instruction Manual

SWITCHING THE POWER ON/OFF

1 Switch the DC power supply ON.
• If operating mobile, skip this step.
2 Press the PWR switch to switch the transceiver ON.
3 To switch the transceiver OFF, press the PWR switch
again.
4 If operating as a fixed station, switch the DC power
supply OFF.
• You may skip step 3. After switching the transceiver
ON, you can switch it OFF or ON using only the power
switch of the DC power supply.
OPERATING BASICS
TM-V708

ADJUSTING THE VOLUME

Turn the VOL control clockwise to increase the audio
level and counterclockwise to decrease the audio level.
• If background noise is inaudible because of the Squelch
function, press the Mic PF key assigned the Monitor
function {page 60}, then adjust the VOL control. Press the
PF key again to cancel the Monitor function.

SELECTING A BAND

Press the left [BAND SEL] to select band A, or the right
[BAND SEL] to select band B.
• "PTT" moves to the selected band.
• For band A and B, see page 17.
4
TM-V708
TM-V708
19