AEG CS MP 850 BT Instruction Manual page 6

4. WIRING DIAGRAM (20 PIN + ISO + SMALL CONNECTOR)
FUSE
7 8 7 8
5 6 5 6
3 4 3 4
1 2 1 2
Figure 1
ISO CONNECTOR 4PIN+8PIN
FEMALE WITH MALE TERMINAL
ISO CONNECTOR WIRING CHART
WIRE COLOR FUNCTION/LABEL
PIN
YELLOW BATTERY(+)
A4
A5 POWER ANTENNA
BLUE
RED
A7 IGNITION(ACC)
A8 BLACK GROUND
B1 VIOLET RIGHT REAR SPEAKER (+)
B2 VIOLET/BLACK RIGHT REAR SPEAKER (-)
RIGHT FRONT SPEAKER (+)
B3 GREY
B4 GREY/BLACK RIGHT FRONT SPEAKER (-)
B5 WHITE LEFT FRONT SPEAKER (+)
B6 WHITE/BLACK LEFT FRONT SPEAKER (-)
B7 GREEN LEFT REAR SPEAKER (+)
LEFT REAR SPEAKER (-)
B8 GREEN/BLACK
20-PIN
AUDIO/POWER
HARNESS
(See Figure 1)
SUB WOOFER
WHITE
GREY
REAR LINE OUT
RED
WARNING Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on the type of vehicle you
drive.Make sure to make the proper connections to prevent damage to the unit.
The default connection for the wiring harness is described in
connector pins are set as described in
1 (Default setting) The 1 pin (red) of the vehicle's ISO connector is linked with
the ignition,and the 3 pin (yellow) is connected to the constant power supply.
Ignition wire
ISO
(RED)
CONNECTOR
(See Figure 1)
Battery wire
(YELLOW)
2
The 1 pin (red) of the vehicle's ISO connector is connected to the constant power
supply, and the 3 pin (yellow) is linked to the ignition.
Ignition wire
(RED)
Battery wire
(YELLOW)
3 The 3 pin (yellow) of the vehicle's ISO connector is not connected to anything,
while the 1 pin (red) is connected to the constant power supply (or both the 1(red)
and 3(yellow)pins are connected to the constant power supply).
Ignition wire
(RED)
Battery wire
(YELLOW)
When the connection is made as in
ignition key. For that reason,always make sure to turn off the unit's power when the
ignition is turned off.
To link the unit's power to the ignition,connect the ignition cable (ACC...red) to a
power source that can be turned on and off with the ignition key.
E - 5
BLUE
RCA-TO-RCA CABLES
WHITE
(not supplied)
RCA-TO-RCA CABLES
(not supplied)
2 or 3
Unit
Unit
Unit
3 above,the unit's power will not be linked to the
ANTENNA
ANTENNA EXTENDER
JACK CABLE
SUB
WOOFER
AMP
1 below. If the ISO
.make the connection as illustrated.
Vehicle
1 PIN (RED)
3 PIN(YELLOW)
Vehicle
1 PIN (RED)
3 PIN(YELLOW)
Vehicle
1 PIN (RED)
3 PIN(YELLOW)