Step
Screw (quantity)
1
M2 × 2 mm, flat-head, nylon-coated (1)
1060 Fingerprint-reader module
Before you replace the fingerprint-reader module, do the following:
1. Disable the built-in battery. See "Disabling the built-in battery" on page 46.
2. Remove the SIM card, SD card, and smart card. See "Removing the SIM card, SD card, and smart
card" on page 46.
3. Remove the back cover assembly. See "1010 Back cover assembly, smart-card reader, and
smart-card-reader cable" on page 48.
4. Disconnect the cable of the built-in battery.
Removal steps of the fingerprint-reader module
The fingerprint-reader module is only available on some models.
Color
Torque
0.196 Nm
Silver
(2 kgf-cm)
.
Chapter 7
Removing or replacing a FRU
57