Clock Adjustment - Kenwood HM-353V Instruction Manual

Clock adjustment

44
As the clock is not only used to show the time of the day but is also used in timer operations, be sure to set
the clock in advance.
1
Activate the clock adjustment mode.
Press and hold for more than 2 sec, when the
power is ON.
2
Enter the figure of hour.
1
Enter the figure of hour.
To decrease
hour
volume / multi control
2
Set it.
set / demo
3
Enter the figure of minute.
1
Enter the figure of minute.
To decrease
minute
volume / multi control
2
Set it.
set / demo
menu
To increase
hour
To increase
minute
T I M E A D J U S T
÷ The time display starts to blink.
Example: Adjustment to 8:07
T I M E A D J U S T
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
Example: Adjustment to 8:07
T I M E A D J U S T
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
set/demo key, the display shows "COMPLETE !".
÷ After a power failure or the power cord has been un-
plugged then plugged in again, it is required to set the
time again.
÷ When the 7 STOP key is pressed while the power is in
the standby mode, the time of the day will be displayed
for 5 seconds.
Timer operation