Plumbing - Miele WS 5243 Operating Instructions Manual

Installation

Plumbing

Connection to the water supply must be car-
ried out by a suitably qualified and competent
person in accordance with local and national
water and safety regulations (DVGW in Ger-
many) via a stopcock, (DIN 1988 approved in
Germany).
To ensure the machine is correctly connected
to the water supply and for drainage please
observe the installation diagram and the in-
stallation instructions supplied with the ma-
chine.
Water inlet / drainage
The inlet pressure hoses supplied with the
machine must be used for connection to the
water supply.
Before connecting the inlet hoses to the ma-
chine the filters and seals supplied in the ac-
cessory pack must first be fitted.
If replacing an inlet hose only use a hose able
to withstand a burst pressure of at least 70
bar, and a water temperature of at least 90°C.
This also applies to all connection parts.
Miele "Original" spare parts meet this require-
ment.
A water pressure flow rate of at least 1 bar,
maximum 10 bar is essential to ensure the
smooth operation of this machine.
Water taken into the machine must not ex-
ceed a temperature of 70°C.
Connection to cold water only
See the Installation diagram supplied.
Water connection Australia
To prevent back-syphonage, the water con-
nection must be via an approved Dual-Check-
Valve.
After installing and connecting the machine
to the services ensure that all outer panels
have been put back in place.
33 M.-Nr. 05730940